APP I PY PE PE 3 10 Plastomer Modified Bitumen Waterproof Membrane

This product is made of filament polyester felt as base material, a non-woven polypropylene (APP) or polyolefin-based polymer (APAO, APO, etc.) modified bitumen is used as a immersion and coating material, and both sides are covered with a waterproof material made of a separator.

According to the physical and mechanical properties, it is divided into I type and II type; according to the upper surface insulation material, it is divided into polyethylene film (PE), fine sand (S), mineral grain (M); according to the surface insulation material, it is divided into fine sand (S ), polyethylene film (PE).

Thickness/mm        3.0             4.0               5.0

Width/m                                  1.0

Length/m               10           10         7.5        7.5

Product Features

●High tensile strength, high water pressure resistance, high elongation, good puncture resistance, fatigue resistance, good dimensional stability and super aging resistance. It has strong adaptability to shrinkage deformation and cracking of the base layer.
●Resistant to chemical corrosion, mold and weather resistance.
●Excellent high and low temperature resistance, suitable for hot and cold areas, especially for building waterproofing in hot areas.
●Good construction performance, hot melt bonding, construction all year round, and seams are reliable and durable.

Scope of Application

●Waterproof and anti-seepage of various industrial and civil building roofs, underground works, and structures such as swimming pools and fire fighting pools. Municipal engineering projects such as subways, tunnels, bridge decks for paving concrete, sewage treatment sites, and landfills are waterproof. Water conservancy facilities such as canals and pools are waterproof.

●Applicable to roofing projects with waterproof rating I and II.

Construction Method

The hot-melt method is adopted, before the construction, the base layer treatment agent (full-adhesive method) should be evenly applied, and then the elastic direction of the construction direction should be determined to determine the position of the coil material, and the coil material is unfolded at the position of the elastic line to release the stress. The coil is rolled from the two ends to the middle, and the hot melt adhesive of the bottom of the coil is baked with a flame spray gun, and the coil is laid from the middle to the both ends, and the paving is compacted by a
press roll to remove air, so that the coil is adhered to the base layer. The knot is firm, the lap joint should overflow the hot-melt modified bitumen, and the blasted parts of the fine sand and mineral granules should be grit-treated, and the detail nodes should be additionally treated, and the lap joint and the head should be sealed. After the acceptance of the polyethylene film-coated coil material, the protective layer shall be set according to relevant specifications and design requirements.

Packaging

After Sales Warranty

Warranty:5 years

After-sale Service:Online Technical Support
After-sale Service:Onsite Installation
After-sale Service:Onsite Training
After-sale Service:Onsite Inspection
Project Solution Capability:total solution for projects
Place of Origin:CN