road marking paint

at present, there are four kinds of color pavement materials: first, color asphalt mixture; second, emulsified color asphalt slurry seal; third, color cement grouting asphalt mixture; fourth, color pavement anti-skid coating, Compared with the previous three kinds of materials, color pavement anti-skid coating has more outstanding anti-skid performance.

Due to the simple construction, rich color variety, relatively stable color fastness, relatively cheap price and outstanding anti-skid effect, the color pavement anti-skid coating has been widely used in bus special roads, highways, toll ports, highway up and down slopes, crossroads, ring islands, bus stops and other traffic accident-prone areas, which has played a good safety warning and anti-skid role. This kind of paint will be used more and more in the pavement of color pavement at home and abroad.

Color anti-skid pavement is widely used in developed countries such as Europe. A large number of comparative data show that its application is not only conducive to traffic congestion, but also an effective means to prevent and control road traffic accidents. The color anti-slip road surface prompts the driver to drive on the prescribed road surface through different road color, thus avoiding the mixing of different vehicles. Prompt the dangerous section in front of the driver and play a good anti-slip effect by providing a high friction surface. The driver can reduce the speed ahead of time and shorten the braking distance by 1/3 in case of emergency to avoid malignant traffic accidents.

Packaging

After Sales Warranty

(1) Hot melt type

This type of coating is physical drying type. Anti-skid aggregate is generally premixed in paint, the construction temperature is above 200℃, the energy consumption is high, but the cost is relatively low, the environmental protection is good, and there is basically no environmental pollution. Because the film is thermoplastic resin, it is easy to deform at high temperature, easy to crack, difficult to construct in large area, and the durability is generally about 2 years.

(2) Two-component cold coating

This type of coating is chemically crosslinked and solidified. At room temperature, the two-component base material is mixed and coated on the road surface during construction, and then the anti-slip aggregate is immediately distributed. The distributed aggregate is non-color anti-slip aggregate, and a layer of color surface should be added. The base material of this kind of coating is generally composed of solvent-free two-component system, but there are some residual monomers in the film forming resin, which has little environmental pollution. Film forming resin is mainly acrylic acid, epoxy resin and other types, good adhesion with the base, strong combination with the road, wear resistance, durability, but slightly higher cost.

(3) Single-component cold coating

This type of coating is physical drying type. Anti-slip aggregate is fine, generally premixed in the paint. Construction at room temperature, because the paint contains volatile organic solvents, serious environmental pollution. The thickness of primary film formation is thin, it needs many spraying to reach a certain coating thickness, and the adhesion to the base is poor, and its wear resistance, durability and coating thickness are related greatly.

Specific parameters are provided according to customer requirements.